Scalable Entry Level 32-bit Microcontroller (MCU) based on Arm Cortex-M0 Cores

LPC1100

The LPC11xx MCU Family is an Arm Cortex-M0 based low-cost 32-bit MCU family operating at CPU frequencies of up to 50 MHz. The LPC11xx MCU family is designed for 8/16-bit micro-controller operations, offering performance, low power, simple instruction set with reduced code size.

The peripheral complement of the LPC11xx family includes up to 64 KB of flash memory, up to 8 KB of SRAM, fast-mode plus I2C-bus interface, RS-485/EIA-485 UART, SPI with SSP features, general purpose counters/timers, an Analog to Digital Converter, and up to 42 general purpose I/O pins.

製品詳細

セクションを選択:

Features

System

  • Arm Cortex-M0 processor, running at frequencies of up to 50 MHz
  • Arm Cortex-M0 built-in nested vectored interrupt controller (NVIC)
  • Non-maskable interrupt (NMI) input selectable from several input sources
  • Serial wire debug
  • System tick timer

Memory

  • Up to 64 KB on-chip flash programming memory
  • Up to 8 KB SRAM
  • In-system programming (ISP) and In-application programming (IAP) via on-chip bootloader software

Digital peripherals

  • Up to 42 General purpose I/O (GPIO) pins with configurable pull-up/pull-down resistors. In addition, a configurable open-drain mode is supported on the LPC1100L and LPC1100XL series
  • GPIO pins can be used as edge and level sensitive interrupt sources
  • High-current output driver (20 mA) on one pin
  • High-current sink drivers (20 mA) on two I2C-bus pins in fast-mode plus (not on LPC1112FDH20/102)
  • Four general purpose counter/timers with up to eight capture inputs and up to 13 match outputs
  • Programmable windowed WDT

Analog peripherals

  • 10/12-bit ADC with up to 2 Msamples/s and up to eight channels

Serial interfaces

  • Up to 3 UARTs with fractional baud rate generation, internal FIFO, and RS-485 support
  • Up to 2 SPI controllers with SSP features and with FIFO and multi-protocol capabilities
  • I²C-bus interface supporting full I²C-bus specification and fast-mode Plus with a data rate of 1 Mbit/s with multiple address recognition and monitor mode (not on LPC1112FDH20/102)

Clock generation

  • 12 MHz internal RC oscillator trimmed to 1 % accuracy that can optionally be used as a system clock
  • Crystal oscillator with an operating range of 1 MHz to 25 MHz
  • Programmable watchdog oscillator with a frequency range of 9.4 kHz to 2.3 MHz
  • PLL allows CPU operation up to the maximum CPU rate without the need for a high-frequency crystal. May be run from the system oscillator or the internal RC oscillator
  • Clock output function with divider that can reflect the system oscillator clock, IRC clock, CPU clock, and the Watchdog clock

Power control

  • Integrated PMU (Power Management Unit) to minimize power consumption during Sleep, Deep-sleep, and Deep power-down modes
  • Power profiles residing in boot ROM allowing to optimize performance and minimize power consumption for any given application through one simple function call
  • Three reduced power modes: Sleep, Deep-sleep, and Deep power-down
  • Processor wake-up from Deep-sleep mode via a dedicated start logic using up to 13 of the functional pins
  • Power-On Reset (POR)
  • Brownout detect with up to four separate thresholds for interrupt and forced reset

Additional features

  • Unique device serial number for identification
  • Single power supply (1.8 V to 3.6 V)
  • Available in WLCSP16, SO20, TSSOP20, TSSOP28, HVQFN24, HVQFN33, TFBGA48 and LQFP48 packages

ドキュメンテーション

クイック・リファレンス ドキュメンテーションの種類.

絞り込み

1-5 の 55 ドキュメント

全て表示

設計・ファイル

絞り込み

5 設計・ファイル

  • モデル

    IBIS models for LPC11xx pkg HVQFN-33

    ZIP改訂 1Jun 13, 201784.2 KBIBIS_LPC11xx_HVQFN-33
    サインインが必要です
    ダウンロード
  • モデル

    IBIS models for LPC11xx pkg LQFP-48

    ZIP改訂 1Jun 13, 201784.2 KBIBIS_LPC11xx_LQFP-48
    サインインが必要です
    ダウンロード
  • シンボルマークと足跡

    LPC43xx/LPC18xx Orcad symbols

    RAR改訂 0Jun 3, 2016297.8 KBLPC43XX-LPC18XX-ORCAD-SYM
    サインインが必要です
    ダウンロード
  • シンボルマークと足跡

    LPC11xx ORCAD symbols

    ZIP改訂 0Jun 3, 20162.9 KBLPC11XX-ORCAD-SYM
    サインインが必要です
    ダウンロード
  • シンボルマークと足跡

    LPC11xx Eagle symbols

    ZIP改訂 0Jun 3, 20168.1 KBLPC11XX-EAGLE-SYM
    サインインが必要です
    ダウンロード

ハードウェア

絞り込み

1-5 の 8 ハードウェア提供

全て表示

ソフトウェア

絞り込み

5 ソフトウェア・ファイル

注: より快適にご利用いただくために、ソフトウェアのダウンロードはデスクトップで行うことを推奨します。

エンジニアリング・サービス

4 エンジニアリング・サービス

本製品をサポートするパートナーの一覧は、 パートナーマーケットプレイス.

トレーニング

絞り込み

2 トレーニング

サポート

お困りのことは何ですか？?

  • Narrow your search
検索