This project shows the use uf the segment LCD driver.

To see value of capacitance on the LCD pins connect the OSJTAG to the terminal utility and press any ky, to see a change on this values, you can remove the LCD panel and measure again.
 

 For information on how to open and use the project refer to the build/cw/cw_readme.txt file.


By default the OS-JTAG is used for the terminal output. The terminal should be configured for 115200 8-N-1.

Supported platforms:
- TWR_K40X256
- TWR_K53N512

There is a project file included for each of the supported platforms. Select the project that corresponds to your hardware.


